P0420 Code: Catalyst System Efficiency Below Threshold

We may earn a commission when you buy through links on this site, at no extra cost to you. As an Amazon Associate I earn from qualifying purchases. Read our affiliate disclosure.

Short answer

If you want to read the code yourself, our pick is the BlueDriver OBD2 Scanner. See the BlueDriver OBD2 Scanner at Amazon.

A P0420 code means your car’s computer has judged the catalytic converter on bank 1 to be working below its efficiency threshold. It makes that call by comparing the oxygen sensor in front of the converter with the one behind it.

The short answer: P0420 often means a worn catalytic converter, but not always. Misfires, exhaust leaks, sensor faults and even engine software can set it. Fix any other codes first, check for factory bulletins on your VIN, and don’t replace oxygen sensors as a guess. The converter may also be covered by the federal 8-year/80,000-mile emissions warranty.

With a steady check engine light and no other symptoms, the EPA says there’s “no cause for panic.” But RepairPal rates P0420 as urgent, and in states with OBD emissions testing, a lit check engine light usually means a failed inspection.

Jump to: What it means · Is it safe to drive? · Causes · How to fix it · A scanner · FAQ

What does the P0420 code mean?

P0420: Catalyst System Efficiency Below Threshold (Bank 1). That’s the generic wording in public code lists, and Honda uses it word for word in a service bulletin. (The original SAE J2012 standard is paywalled, so we haven’t read its text.)

  • How it’s set: according to RepairPal, the engine computer “compares the front and rear oxygen sensors” to judge how well the converter is working. A healthy converter evens out the rear sensor’s signal. When the rear sensor starts switching like the front one, the converter isn’t storing oxygen well, and the code sets.
  • Bank 1 is the side of the engine with cylinder 1. P0430 is the same code for bank 2.

Is it safe to drive with a P0420 code?

  • Steady light: the EPA’s OBD brochure says, “There is no cause for panic. The vehicle is just telling you to seek attention soon.”
  • Flashing light: the EPA says “a severe engine problem such as a catalyst-damaging misfire is occurring and should be addressed as soon as possible.” That’s a misfire problem; see our P0300 misfire guide.
  • Don’t put it off: RepairPal rates P0420 “Urgent,” and in states with OBD emissions testing, a lit check engine light usually means a failed inspection.

For what a solid or flashing light means with any code, see check engine light on? what it means and what to do.

Symptoms

  • A check engine light. RepairPal says, “in most cases, there are no adverse conditions noticed by the driver.”
  • Sometimes a lack of power, if the converter is restricted or damaged (RepairPal).
  • Rough idle or misfires, if another fault is behind the code (Identifix).

What causes a P0420 code?

  1. A worn or failed catalytic converter. RepairPal lists “Inefficient Catalytic Converter(s)” first.
  2. A front or rear oxygen sensor, or its wiring. RepairPal also lists oxygen sensors as a common misdiagnosis, so test before you replace.
  3. Misfires. RepairPal lists “Misfiring engines.” Fix any P0300 to P0308 code first.
  4. An exhaust leak near the oxygen sensors (Identifix).
  5. A coolant temperature sensor or thermostat fault (Identifix).
  6. Engine software. Several automakers have issued bulletins that address P0420 with a computer update (see below).

Why the root cause matters: converters usually fail because of another problem, such as a misfire or an engine burning oil or coolant. RepairPal and Identifix both warn that if you don’t fix that first, the new converter can fail too.

Known factory fixes for P0420

Check your VIN first. A service bulletin or warranty extension applies only to the vehicles it lists, often only certain model years, engines or build dates. It doesn’t mean every car of that model has the problem, or that yours does. Ask a dealer to run your VIN for open bulletins, recalls and warranty extensions before you buy parts.

  • Honda Service Bulletin 22-040 (September 21, 2022): “MIL Is On with DTC P0420,” some 2014–2016 CR-Z. Read it on NHTSA.
  • GM bulletin 19-NA-057 (February 2020): “Malfunction Indicator Lamp (MIL) Illuminated, DTC P0420 Set,” 2013–2015 Buick Encore and Chevrolet Trax with the 1.4L engine (RPO LUV). Read it on NHTSA.
  • Kia TSB ENG160 Rev 1: an ECU upgrade for “MIL ON with DTC(s) P0420/P0171” on certain 2011–2016 Optima, Sorento and Sportage. Read it on NHTSA.
  • Hyundai TSB 16-FL-005: “DTC P0171/P0420 ECM update and P0420 catalyst replacement,” certain 2011–2014 Sonata 2.4L GDI. Read it on NHTSA.
  • Honda Service Bulletin 22-002: a fuel-injector warranty extension on certain 2015–2016 Fit, covering a check engine light with codes including P0420, for “10 years from the original date of purchase or 150,000 miles, whichever comes first.” Many 2015–2016 Fits are now past the 10-year term; check your VIN. Read it on NHTSA.

Is the catalytic converter under warranty?

Possibly. Under federal rules (40 CFR 85.2103), catalytic converters and the emission control module are “specified major emission control components” with an 8-year/80,000-mile warranty (plus particulate filters and some diesel and EV parts). California and other states that follow its rules may have different coverage; we haven’t researched those. Ask the dealer to check your VIN and mileage.

How to diagnose P0420 (and how a scanner confirms it)

What you can do with a scanner

  1. Read all stored and pending codes. Fix misfire (P0300 to P0308) or lean (P0171, P0174) codes first. See our P0171 guide.
  2. Save the freeze frame before clearing anything, then watch short- and long-term fuel trims (Identifix).
  3. Check the readiness monitors. The catalyst monitor’s status shows whether the car has finished its self-test since codes were last cleared (New York and Missouri inspection programs).
  4. View Mode 6 results, if your app shows them. MOTOR Magazine shows how to compare the catalyst test’s current result with its passing limit. A thin margin means the code is likely to come back.
  5. Graph the front and rear oxygen sensors. A rear sensor that switches like the front one supports a tired converter (RepairPal; MOTOR).
  6. Look and listen for exhaust leaks near the sensors.
  7. Ask a dealer to run your VIN for bulletins, campaigns or warranty coverage.

What a shop does

A shop rules out misfires, fuel problems and leaks, graphs the oxygen sensors, checks the engine computer’s software level against bulletins, and may run an oxygen-storage test. In a 2011 column on Honda P0420 diagnosis, MOTOR Magazine says a healthy converter’s outlet is usually “noticeably hotter than the inlet; a practical rule of thumb is about 10% hotter,” measured at a steady 2,000 rpm. Treat it as a supporting check, not proof, and follow the maker’s diagnostic procedure. If the converter needs replacing, Identifix recommends an OEM-spec part, and RepairPal notes that Toyotas often need OEM.

How to fix a P0420 code

  • Repair the underlying misfire, fuel or exhaust-leak problem, then let the catalyst monitor run again.
  • Replace an oxygen sensor only once it’s confirmed bad.
  • Get a computer software update if a bulletin applies to your VIN.
  • Replace the catalytic converter with a correct OEM or emissions-legal part. Rules differ by state.
  • Then drive enough to complete the catalyst monitor before inspection. North Carolina’s DEQ suggests one to two weeks of normal driving, including some highway.

Repair costs vary widely by car, so the diagnosis decides the bill.

A scanner to check P0420 yourself

Any OBD2 scanner reads the code. For P0420, you’ll also want readiness monitors, freeze frame and, ideally, Mode 6. These are the three picks from our best Bluetooth OBD2 scanner guide:

We may earn a commission when you buy through links on this site, at no extra cost to you. As an Amazon Associate I earn from qualifying purchases. Read our affiliate disclosure.

  • Best overall: BlueDriver OBD2 Scanner (Bluetooth). Car and Driver’s Best Bluetooth Scanner in its 2026 test. Its listed features include live data, freeze frame, smog readiness and Mode 6, with no subscription.

    Where to buy: Check price at Amazon · Check price at Walmart · Check price at BlueDriver

  • For enthusiasts: OBDLink MX+. Works with iOS, Android and Windows, adds MS-CAN and SW-CAN for Ford and GM, and pairs with apps like FORScan. Check the current price at Amazon.
  • Budget: Veepeak OBDCheck BLE. A small ELM327 adapter that works with third-party apps. Check the current price at Amazon.

We’ve confirmed Mode 6 only for the BlueDriver. With the OBDLink and Veepeak, Mode 6 depends on the app you pair them with.

How we built this guide

We did not diagnose any cars for this guide. Mike re-read every source on November 17, 2026: RepairPal, Identifix’s P0420 guide (updated October 21, 2026), the EPA’s OBD brochure (from 2002, in the EPA’s archive), the EPA’s warranty FAQ, MOTOR Magazine, and the manufacturer bulletins on NHTSA linked above.

More in this topic: Car tech start-here guide.

For our full process, see how we choose the gear we recommend.

FAQ

Is P0420 always the catalytic converter?

No. It’s often the converter, but misfires, exhaust leaks, oxygen sensors, a coolant temperature fault or engine software can set it. Fix other codes and check bulletins first.

Can I fix P0420 without replacing the catalytic converter?

Sometimes. If the cause is a misfire, an exhaust leak, a confirmed-bad sensor or software covered by a bulletin, fixing that can clear it. If the converter itself is worn, it needs replacing.

Why did P0420 come back after I replaced the oxygen sensor?

Because the sensor probably wasn’t the problem. RepairPal lists oxygen sensors as a common misdiagnosis for P0420. In one r/MechanicAdvice thread (an unconfirmed owner account), a 2012 Legacy owner got a P0420 a few months after fitting a new downstream sensor. Test before you replace.

Why did P0420 come back after a new catalytic converter?

The cause that killed the first one, such as a misfire or oil or coolant burning, may still be there. A non-OEM-spec converter can also set the code again (Identifix).

Is my catalytic converter covered by warranty?

Federal rules give the converter an 8-year/80,000-mile warranty (40 CFR 85.2103; EPA FAQ). Check your VIN and mileage with a dealer. Some states may have different rules.

Will clearing the code let me pass inspection?

No. Clearing codes resets the readiness monitors, and New York’s and Missouri’s inspection programs check them. The car needs to finish its self-tests, and if the fault is real, the code returns.

What’s the difference between P0420 and P0430?

Same fault, different side. P0420 is bank 1 (the side with cylinder 1), and P0430 is bank 2.

Related codes

Fix these first if they’re stored with P0420: P0300 random misfire and P0171 system too lean. For EVAP codes, see P0442 and P0455.

Leave a Comment