Peak Amps vs Cranking Amps: What Jump Starter Numbers Mean

We may earn a commission when you buy through links on this site, at no extra cost to you. As an Amazon Associate I earn from qualifying purchases. Read our affiliate disclosure.

Short answer

For a jump pack chosen by engine-size rating, stored energy and independent load tests rather than peak amps, our pick is the WOLFBOX MegaVolt24. See the WOLFBOX MegaVolt24 at Amazon (choose the MegaVolt24 / 4000A version).

Peak amps vs cranking amps: the big “peak amps” number on a jump starter box is not a measure of starting power. It can describe a burst lasting about a tenth of a second. What actually starts your car is the current a pack can sustain while holding its voltage, and how much energy it stores.

The independent tests prove it. CNN Underscored put a jump starter advertised at 4,000 peak amps on a load tester and measured roughly 360 to 480 amps. AAA’s Greg Brannon told CNN that peak amps are “probably more of a marketing term than reality.”

The short answer: ignore the peak number. Choose a pack by its engine-size rating, its stored energy in watt-hours, and independent load-test results. Most four-cylinder and V6 engines need only about 100 to 150 amps to start. For a pack that does well on those measures, our pick is the WOLFBOX MegaVolt24.

Jump to: The numbers on the box · How many amps you need · Measured vs. claimed · Which jump starter to buy · FAQ

Peak amps vs cranking amps: the numbers on the box

Number What it means How much to trust it
Peak amps The most current the pack can deliver in an instant Low. Under UL 2743, a declared peak can be tested for as little as 100 milliseconds.
Cranking or “starting” amps A sustained current figure Medium. Each brand defines it unless it’s tied to a UL ampacity rating with a stated duration.
Engine-size rating The largest gas and diesel engines the maker says it can start (for example, “up to 6.0L gas / 3.0L diesel”) Useful as a guide, but it’s still the maker’s claim
Cold cranking amps (CCA) A defined battery rating, not a jump-pack rating High for car batteries. Treat a pack’s “CCA-equivalent” as a claim unless the method is stated.

What “peak amps” really measures

Jump-pack amp claims now have a test method in ANSI/CAN/UL 2743, the standard for portable power packs (Intertek’s notice on the update was issued March 18, 2026, and certified packs must meet the new edition by September 24, 2027). Its “Power Pack Ampacity Test” loads a lithium-ion pack for 5 seconds (lead-acid for 10 seconds) at the maker’s stated maximum current. If a maker declares a peak current, the test is repeated at that peak “for a duration of 100 ms or a duration specified by the manufacturer, whichever is longer,” and the peak and its duration must be included in the rating.

In other words, a legitimate peak figure can describe a tenth of a second. We couldn’t check whether any specific pack is UL 2743-listed, so look for the UL mark and its stated duration on the pack you’re considering.

What cold cranking amps (CCA) means

The Battery Council International defines CCA as “the discharge load in amperes which a new fully charged and conditioned battery at -18°C (0°F) can continuously deliver for 30 seconds and maintain a terminal voltage equal to or higher than 1.20 volts per cell (7.2 V for a 12 V battery).” It’s the number on your car battery’s label, and it’s a sustained, cold, 30-second test, very different from a jump pack’s peak.

How many amps does your engine actually need?

  • About 100 to 150 amps for a four-cylinder or V6. Timothy Hatcher of the Automotive Maintenance and Repair Association told CNN Underscored, “starting a four-cylinder (engine) or a V6, you’re talking 100, 150 amps.”
  • A jump starter rated at 400 to 500 cold cranking amps should be enough for passenger cars, SUVs and pickup trucks, according to Consumer Reports’ jump starter buying guide (archived; it no longer updates this category). That’s the pack’s rating, not your battery’s CCA.
  • Cold raises the demand. AAA says a battery loses about 60% of its strength at 0°F, and starting may need up to twice the current.

So how big a pack do you need? It depends on your engine and climate. A four-cylinder or V6 in a mild climate: a compact pack whose engine rating covers your engine. A V8, a diesel or hard winters: a pack with a bigger engine rating and more watt-hours, with room to spare.

Measured vs. claimed: what the independent tests found

Jump starter Box claim Defined rating Independent measurement
GOOLOO GT4000S 4,000A peak 800A cranking/starting (GOOLOO manual) CNN Underscored: about 360A at 9.5V, 480A at 7.5V, then 420A at 9.5V (about 3,500W).
NOCO GB40 1,000A peak None published CNN Underscored: 160A at 7V; 100A at nearly 10V. It held its output longer than rivals.
NOCO GBX155 4,250A None published None we could confirm
Clore Jump-N-Carry JNC325 2,000A peak 450 Start Assist Amps (Clore) No load test in our sources
WOLFBOX MegaVolt24 4,000A peak None we could confirm No load-tester amps. TechGearLab measured 82.3Wh of capacity against 88.8Wh claimed.
GOOLOO GP2000 2,000A peak 400A starting current (GOOLOO manual; test method and duration not stated) None found

Test results are CNN Underscored’s.

Notice that the GB40, rated at a quarter of the GT4000S’s peak, still delivers enough sustained current for most four- and six-cylinder engines. That’s why the engine rating and independent tests matter more than the peak.

What to look at instead of peak amps

  • Sustained output in independent tests, such as CNN Underscored’s load tests and Project Farm’s videos.
  • Stored energy in watt-hours (Wh), measured if possible. It’s a better predictor of how many tries you’ll get. TechGearLab measured the NOCO GB40 at 15.6Wh against 24Wh claimed, and the NOCO GBX155 at 86.1Wh against 99Wh claimed.
  • The engine-size rating, with headroom for your engine.
  • Lead length, so the clamps actually reach your battery.
  • The cold operating range, if you live somewhere with hard winters.
  • A defined rating, like Clore’s Start Assist Amps, which Clore uses instead of peak amps and explains in its “Anatomy of a Jump Starter” guide.

A safety note: boost or manual-override modes force power to the clamps. NOCO’s GB40 guide warns its override “disables all safety measures,” and CNN Underscored gives the same warning. Double-check your connections before you use it.

We may earn a commission when you buy through links on this site, at no extra cost to you. As an Amazon Associate I earn from qualifying purchases. Read our affiliate disclosure.

Which jump starter to buy

Our pick: the WOLFBOX MegaVolt24, the best overall in our jump starter guide. TechGearLab measured its capacity close to the claim, and in its test it started a V6 with a dead battery three times in a row. On Amazon, choose the MegaVolt24 / 4000A version on the page.

Where to buy: Check price at Amazon · Check price at WOLFBOX

  • Best value: the GOOLOO GT4000S, which CNN Underscored measured at roughly 360 to 480 sustained amps.

    Where to buy: Check price at Amazon · Check price at GOOLOO

  • Budget pick: the GOOLOO GP2000, TechGearLab’s Best Bang for the Buck, for cars and crossovers. Check the current price at Amazon.

Full reviews are in our best jump starters guide. Comparing NOCO’s compact packs? See NOCO GB40 vs GBX55. Stuck right now? Here’s how to jump start a car in cold weather.

How we built this guide

We did not test these packs ourselves. Mike re-checked the quotes from CNN Underscored’s April 2026 load test on November 17, 2026, and used the primary texts of the Battery Council International glossary and Intertek’s UL 2743 notice. We used Project Farm’s 2022 video as background only, and the Consumer Reports and TechGearLab figures come from the sources in our jump starter guide. We checked every linked product’s Amazon page on November 17, 2026.

More in this topic: Safety and emergency start-here guide.

For our full process, see how we choose the gear we recommend.

FAQ

Do peak amps matter?

Not much. A declared peak can be tested for as little as 100 milliseconds under UL 2743, and AAA’s Greg Brannon calls it “probably more of a marketing term than reality.” Look at sustained output, watt-hours and the engine rating instead.

What’s the difference between cranking amps and cold cranking amps?

Cold cranking amps is a defined battery rating: the current a fully charged battery can deliver for 30 seconds at 0°F while staying at or above 7.2 volts (Battery Council International). A jump pack’s “cranking” or “starting” amps are usually defined by each brand.

How many amps do I need to jump-start a car?

About 100 to 150 sustained amps for a four-cylinder or V6, according to AMRA’s Timothy Hatcher, via CNN. Pick a pack whose engine rating comfortably covers your engine, with more headroom for cold weather.

Is a 1,000-amp jump starter enough?

For many cars, yes. The 1,000A NOCO GB40 sustained 100 to 160 amps in CNN’s test. For V8s, diesels or hard winters, choose a pack with a bigger engine rating.

Is a 4,000-amp jump starter really 4,000 amps?

Not in sustained output. CNN measured the “4,000A” GOOLOO GT4000S at roughly 360 to 480 amps under load, which is still plenty for most cars.

What’s the difference between amps, volts and watts?

Watts equal amps times volts, as CNN Underscored explains. That’s why test results list both: 480 amps at 7.5 volts is about 3,600 watts.

Leave a Comment